![]() Extruder Calibration: How to Calibrate E-Steps. That loads in the default calibration cube they used for their 3mf and a print, filament and printer profile. To me, it looks like the first layer is a bit to smushed - try using live adjust Z to raise it up a bit. Cube printed at 250C – perimeter measured at 1. With the near failure (a 20mm calibration cube), I noticed the corners of the cube had lifted up off the print bed towards the end of the print, and the bottom of the cube is visibly rounded (the cube is 0. Calibration cube first layers problem Pagina 1 / 2. Please remember to include the following details to help troubleshoot your problem. After a few month hiatus been getting back into the prusa mk3s. ![]() The Sovol SV04 is a good IDEX 3D printer with good specs and hardware configuration, which can work really well if you update the firmware to the latest available version. ⬢ The fifth LED near the right edge will start flashing. Size it to 100,5 % if you don't get any walls in the print preview.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |